I think you can find it on the LSI site, just be sure to get the right one, 32 or 64bit. Dear Jim, In XenServer 3. Thanks for your feedback! I also needed to find my NIC info as well, so I typed “modinfo [device]” and it gave me the driver version there. Hello, I am currently trying to find out what driver version I am using for my server. Sorry if I post is in wrong place.
|Date Added:||10 January 2012|
|File Size:||55.67 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
In our next release we will have support to install to a RAID volume. Apologies for the inconvenience.
I Do Linux: FakeRAID & CentOS / Red Hat 5
I’m kind of confusing about raid knowledge now, don’t know if mine is hardware one. Join our community today! I also needed to find my NIC info as well, so I typed “modinfo [device]” and it gave me the driver version there.
Linux just recognise the raid as a device. Please visit this page to clear all LQ-related cookies. Does this answer the question somewhat? Any further suggestions, or should I consider the mdadm route as documented elsewhere in the forum?
Hi bros, lspci 631xesb/632xeb shows this: I think you can find it on the LSI site, just be sure to get the right one, 32 or 64bit. Note that registered members see fewer ads, and ContentLink is completely disabled once you log in.
CONFIG_ATA_PIIX: Intel PIIX/ICH SATA support
You are currently viewing LQ as a guest. Here are what I think would be the relevant outputs from the system when I put two scratch drives in the machine, create a simple striped RAID0 set across them and install CentOS 5 into that striped set: If it’s on the builtin intel chipset, ya it’s fakeraid.
Dear Jim, In XenServer 3. This book contains many real life examples derived from the author’s experience as a Linux system and network 631xesb/6332xesb, trainer and consultant. And also, I like to monitor the hard disk status without stopping the machine, it hosts some web sites.
Embedded SATA RAID on HP ML – Storage – Discussions
Ritesh, Thanks for that – I will look forward to the new release. Please sign in to comment You will be able to leave a comment after signing in Sign In Now.
Basically, it’s an on-board embedded megaraid, I create the raid array in BIOS with megaraid utility, then installed ubuntu normally on the array without any further driver installation lspci show me this: Unless you need to dual boot with windows, you should not use the fake raid support since it is not as robust; use mdadm Linux software raid instead. Hi, I have tried configuring the RAID as both 0 and 1 from the bios as I only have two drives those are the only options available to me.
CONFIG_SATA_AHCI: AHCI SATA support
CentOS5 appears to automatically do so as part of its installer, and I am presented with a choice of three drives sda, sdb and the dmraid detected array of the two. The time now is There are some motherboards that have used their chips, so it could be in there.
Posted May 21, I need to find the driver version for my disk controller Hello, I am currently trying to find out what driver version I am using for linix server. We are working on a fix. You often configure and check status of the raid during bios boot. Link is as follows for anyone interested: Posted May 11, Posted May 9, Sorry if I post is in wrong place. Guest Enthusiast 14 Members 6, posts.